![]() Enter 73 on the touch tone pad to disconnect EchoLink. Please remember you may be connecting to a repeater, link, or user in the middle of a conversation. Please wait for this greeting to finish before you begin to make a call. You will be greeted by a "now connecting to xxxxx" message. In the case of EchoLink, the node numbers can be up to 6 digits. The access for EchoLink is similar to that of IRLP, but you must start the touch tone command with the A button first followed by the node number. Enter 73 on the touch tone pad to disconnect. Please remember you may be connecting to a repeater in the middle of a conversation. You will be greeted by a "now connecting to" message. For an IRLP connection, simply touch tone the 4 digit node number of the station you want to connect to. Almost all the connections on repeaters using IRLP software will be high speed DSL, T1 or cable modem connections. They also better control the speed of the connections required for the use of IRLP software. They tend to frown on repeaters that do not strip their courtesy tones, hang time and IDs from the Internet side of the connection. The audio quality tends to be better on IRLP since it has more control over the repeaters in the system. ![]() ![]() The conference servers are located at wide pipe portals and have the ability to have more than 50 repeaters connected at the same time. These connections are repeater to repeater connections and currently do not allow users to connect directly from their computers. IRLP software has the ability to connect the club's repeaters to other repeaters or to connect to conference servers located throughout the world. īoth are free, but require that you register to ensure that you are a ham before you can download the software. EchoLink software (for PCs) is available at. Please make sure to forward UDP ports 5198 - 5199 and TCP port 5200 if you are behind a router or firewall. The user software is available for both PCs and Macs (EchoMac). For the MDARC repeaters this number is currently set for 5. This connection has the ability to be made to several different stations at the same time and can be set to a maximum number, depending on the speed of the Internet connection. ![]() The first is EchoLink, which allows a user to connect to other hams that are logged on to the EchoLink network as a repeater, link or user. The EchoIRLP software consists of two separate software systems. ![]() The new system is currently accessible from the club's 2M repeater at 147.060 MHz. This EchoIRLP software allows a user to connect the MDARC repeaters to other repeaters or individuals around the world and carry on a voice conversation with those distant stations. This system is currently running RedHat 9.0 and has EchoIRLP software installed on it. MDARC runs a VoIP (Voice over Internet Protocol) computer on the top of Mt. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |